Commercial interfaces
Keeping the shopfront while stripping the unit behind it
A shopfront can remain in place while the interior fit-out changes, but the threshold between them must be defined. Display platforms, signs, electrical feeds and ceiling details may connect to the frontage. The landlord and designer should identify the retained shopfront assembly before the removal scope reaches it.
Mark the retained frontage in elevation
Photograph glazing, door frames, display bases, signage and the ceiling edge. Add an elevation or marked image showing where removal stops. Do not infer that a display feature is separate from the frontage because it sits on the tenant’s side of the glass. Ask the responsible specialist to assess unclear connections.
Plan movement without using the frontage as access
If the front doors are the debris route, measure and record the clear opening and threshold condition. The contractor must assess a workable route; a narrow opening does not authorise removing glazing. Check other loading arrangements with management before the quote assumes all material leaves through the shopfront.
Hand the edge to the fit-out team
Agree who repairs signs, lighting, floor transitions and ceiling finishes where the new interior meets the retained frontage. Include a condition record before removal. Bolan can assess the strip-out to the marked line while any specialist frontage change remains a separate approved scope.
Prepare this decision for the assessment
Bring these details to the site discussion so the removal scope reflects the parts of your property that are changing.
- Frontage elevation with stop line
- Approved debris route
- Fit-out responsibility at retained edges
Continue planning the work
Discuss the property through our commercial strip out service and use the local directory for address-specific preparation.